Removing VLAN settings

You can remove interfaces from VLANs using the VLAN Remove template.

Procedure

Complete the following steps to create a VLAN Remove template.

1. From the XClarity Administrator menu bar, click Provisioning > Switch Configuration Templates. The Switch Configuration Templates page is displayed.
2. Click VLAN > VLAN Remove in the left navigation, and then click the Create icon ().
3. In the Create New Template dialog, specify the following information.
   Important

   You must specify one or more physical L2 interfaces or port channel IDs.

   • Enter a name and description for the template.

   • Specify one or more valid physical L2 interfaces. You can specify a list of interfaces separated by a comma, a range of IDs separated by a dash, or a combination of both, for example:

     • Ethernet1/10

     • Ethernet1/1,3,5,7

     • Ethernet1/1-10,21-30

     • Ethernet2/1-5,7,9,11-13

   • Specify one or more valid port channel IDs (port aggregator interfaces). You can specify a list of numbers separated by a comma, a range of numbers separated by a dash, or a combination of both. The values and ranges can be numbers from 1-4096, for example:

     • 10

     • 1.3,5,7

     • 1-10,21-32

     • 1-5,7,9,11-13

   • Specify one or more VLAN IDs to remove from the port's VLAN membership list. You can specify a list of numbers separated by a comma, a range of numbers separated by a dash, or a combination of both. The values and ranges can be numbers from 1-4096, for example:

     • 10

     • 1.3,5,7

     • 1-10,21-32

     • 1-5,7,9,11-13

     Note

     If the port mode is set to access, removing the VLAN causes the port to go in VLAN 1.
4. Click Create to save the template, or click Create and Deploy to save and immediately deploy the template to one or more managed rack switches.

   For information about deploying a template, see Deploying switch-configuration templates to a target switch