XClarity Essentials OneCLI has the following known general limitations.
- OneCLI does not support to mount/unmount virtual media
under in-band mode.
- OneCLI retrieves a temporary account
from BMC when running in-band scenarios, but the temporary account
does not have the privilege to mount/unmount virtual media.
- OneCLI does not support inventory and raid configuration
on Virtual Raid on CPU (VRoC).
- The glibc.i686 and glibc-locale libraries
are required to load shared libraries.
- If the glibc.i686 and
glibc_locale libraries are not installed, users might receive the
following error when attempting to load a shared library:
OneCli
error while load shared libraries: libstdc++.so.6: cannot open shared
object: no such file or directory
.
- OneCLI uses BMC Lan over USB which uses "169.254.95.
xx" network by default.
- The default setting for BMC Lan-over-USB
is "169.254.95.xx". If the "169.254.95.xx" network is used for another
application, such as Oracle RAC, running OneCli will change the network
route table, which can cause the other application to behave unexpectedly.
In this case, set the IP address in the "BMC Ethernet over USB IP
Settings" section of the BMC Web page to a non-conflict IP address
so that OneCli will use this IP address to connect to BMC.
- OneCLI might print warning message when Broadcom
CIM provider v17.0.5 or older installed on a customized the VMware
ESXI system.
- If users have a Broadcom CIM provider v17.0.5
or older installed on a customized the VMware ESXI system, the following warning message will be displayed in the
log file: You have a Broadcom CIM provider v17.0.5 or
older installed in the target system. Broadcom CIM Provider versions
older than 17.0.5 is not recommended to use for Firmware Update. If
you want to update Firmware, install the latest ESXi patch."