Drive uncertified

Important:
  • Refer to your hardware documentation or contact a Technical Support Engineer for information on which drives are certified for your storage array.

  • You can replace the uncertified drive while the storage array is receiving I/O.

  • Make sure the replacement drive has a capacity equal to or greater than the uncertified drive you will remove.

CAUTION:
Electrostatic discharge can damage sensitive components

Always use proper anti-static protection when handling components. Touching components without using a grounding wrist strap may damage equipment.

Recovery Steps

  1. Remove the drive shown in the Details area. Its fault indicator light should be lit.

  2. Wait at least 30 seconds after removing a drive before inserting a new one.

  3. Insert a new drive. Its fault indicator light may be lit for a short time (one minute or less).

  4. Select Recheck to ensure the problem has been resolved.