Skip to main content

Configuring SNMP

Use the information in this topic to configure SNMP agents.

Complete the following steps to configure the XClarity Controller SNMP alert settings.

  1. Click Network under BMC Configuration.

  2. Check the corresponding check box to enable the SNMPv1 Trap, SNMPv2 Trap and/or SNMPv3 Trap.
  3. If enabling the SNMPv1 Trap or SNMPv2 Trap, complete the following fields:
    1. In the Community Name field, enter the community name; Name cannot be empty.
    2. In the Host field, enter host address.
  4. If enabling the SNMPv3 Trap, complete the following fields:
    1. In the Engine ID field, enter the engine ID. Engine ID cannot be empty.
    2. In the Trap Receiver Port field, enter the port number. Default port number is 162.
  5. If enabling the SNMP Traps, select the following event types you wish to be alerted:
    • Critical
    • Attention
    • System
    Note
    Click on each major category to further select their sub-category event types you wish to be alerted.